[Russian][Main] [Contact us]
 
  Products:
      TR-GEO-R
      TR-GEO-01
      MIRADOR
      GEOSCOPE
      TR-GEO-01 (MOBILE)
       
  Our works:
      In tunnels
      On roads
      On railroads

      On building

      On water surface

      In reconstruction geological slices

      Seismic profiling
     
  Software:
      RADAR
       
  Other:
     
     

Publications about us
     
Conference GPR 2010
   
  Georadar TR-GEO-01 (MOBILE)
   
 
   
  General:
    Mobile georadar is robot-based georadar complex. It can be controlled by radio channel and can carry out self-sounding. This georadar is equipped with video cameras and additional infrared light device. This georadar can transmit super broadband sounding video pulses. It allows for sounding of structures with low and moderate attenuation of radio waves: sandy dry and wet grounds, loam grounds with low moisture content, rocky ground and frozen ground. This georadar detects metallic and dielectric objects and can identify the type of the object.  
 
  Application:
    This georadar is suited for
- geophysical surveying, making and specifying of images of geological cross-sections.
- sounding of metallic and dielectric objects of no less than about 0,3 - 0,5 m in size as well as cables and pipes.
- detection of karst cavities and large boulders.
- sounding of borders of water lenses, alluvial cuttings .
- sounding of voids and wet zones beneath pavement.
 
 
  Technical options and parameters:
      Depth of sounding:
  - in dry sandy ground, rocky ground - 20 m
  - in wet sandy ground, limestone - 10 m
  - in loam grounds with low moisture content - 3- 5 m
  Minimum sizes of objects :
  - local objects - 0,3- 0,5 m , linear objects - 7- 10 cm .
 
 
  Operating procedure:
    The antennas move over ground or at small height above ground along parallel lines. The best results are achieved with close contact between antennas and ground. To increase the depth of sounding it is possible to make measurements with increased distance between antennas and to stack signals. The receiving unit includes controller and flash memory. At measurements the signals are being recorded into flash memory. After measurements the data are transferred to computer and undergo processing. Following signal processing and focusing vertical and horizontal sections as well as three-dimensional image are displayed.  
   
   


 
 
e-mail: inter@trgeo.ru
tel.: (495)-619-78-94
fax: (495)-618-50-69